Filter
Top Products
4-19
REMOVING A SIDE PANEL
1. Unplug range or disconnect power.
2. Pull the range away from the wall so that
you can access the rear of the unit.
3. Remove the oven door and set it aside
(see page 4-22 for the procedure).
4. Pull the storage drawer out as far as it will
go.
5. Remove the two rear screws from the side
panel.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Screw
Screw
Side Panel
6. From the rear of the unit, reach inside and
remove the screw from the bottom of the
side panel.
7. Slide the side panel forward and unhook
the front edge, then tilt the top of the side
panel out, and lift the panel from the unit.
Slide Forward & Tilt
Top Of Panel Out
Remove Bottom
Side Panel Screw
NOTE: When reinstalling the side panel, set
the bottom edge on the rail, hook the front edge
at the top and bottom, and install the two rear
screws; then install the bottom screw from
inside the rear of the unit.
Screw
(Inside)