Filter
Top Products
4-2
REMOVING THE CONTROL PANEL,
AN INFINITE SWITCH & BIMETAL SWITCH
b) Remove the wires from the infinite
switch terminals and remove the switch.
NOTE: The terminal callouts are shown
on the next page.
Single Element
Infinite Switches
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug range or disconnect power.
2. Pull the range forward far enough to ac-
cess the end cap screws.
3. To remove the control panel:
a) Remove the screw from each end cap.
Control Panel
4. To remove an infinite switch:
a) Pull the knob off the switch you wish to
service and remove the nut and fiber
flat washer.
Infinite Switches
Single Dual
c) Lift the front of the control panel, pull it
forward, and slide the front edge of the
cooktop glass out of the slot in the front
of the panel.
d) Rotate the control panel up and over so
the bottom side faces up.
Bottom Control Panel Screws
Ambient (N.C.)
Bimetal Switch
Opens @ 96°C (205°F)
Resets @ 74°C (165°F)
End Cap
Screw
Remove Knob
Cooling Fan (N.O.)
Bimetal Switch
Resets @ 70°C (158°F)
Closes @ 60°C (140°F)
b) Open the oven door and remove the
three screws from the bottom of the
control panel (see the photo at the top
of the right column).
Remove Nut &
Fiber Flat Washer