Filter
Top Products
4-4
4. To remove an indicator light:
a) Push on the body and slide it off the
shoulder of the lens.
b) Disconnect the two indicator wires.
Lens
REMOVING THE ELECTRONIC OVEN CONTROL
AND AN INDICATOR LIGHT
1. Unplug range or disconnect power.
2. Remove the control panel from its
subchassis, (see page 4-2 for the proce-
dure), and rotate it forward onto the cooktop
glass.
3. To remove the electronic oven control:
a) Disconnect the wire connectors at P1,
J1, P2, P3, and P4.
Electronic Oven Control
b) Press down on the ribbon cable release
arm, and disconnect the ribbon cable
from the connector at P9.
Screw
P2
P3
P4
P1
Ribbon Cable Release
(2) Indicator Lights
(3) Indicator Lights
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Ribbon Cable Connector
Screw
J1
P9
Screw
c) Remove the screws from the board.
d) Straighten the bracket tabs at the top
and bottom of the board, and remove
the board from the bracket.
Tabs
Push
Indicator Light
Wires