Filter
Top Products
4-6
6. To remove the hot surface indicator
assembly:
a) Disconnect the hot surface indicator
wires.
c) Lay the element and limiter on a work
surface. Remove the screws from the
limiter and remove it from the element.
NOTE: Be careful when you remove
the limiter that you do not break the
sensor tube (see below).
Limiter
Screws
b) Grasp the hot surface indicator assem-
bly and push it toward the front of the
unit, then pull down the rear edge,
unclip the locking arms from the
cooktop, and remove the assembly.
Black Brown
Yellow Violet Blue
Hot Surface
Indicator
Assembly
Locking Arms
Sensor Tube