Filter
Top Products
4-15
d) Remove the three screws from the con-
vection fan motor.
e) Disconnect the wires from the termi-
nals.
3 Screws
Convection Fan Motor Wires
b) Pull the range away from the wall so
that you can access the rear of the unit.
c) Remove the rear panel (see step 3a on
page 4-10 for the procedure).
Cap Nut
Convection
Fan
Convection Fan Motor
b) Pull the bake element forward so the
wire connectors are accessible, then
disconnect the wires from the termi-
nals. NOTE: Be careful that the wires
do not pull back into the oven liner hole.
Convection Bake Element Wires
5. To remove the convection fan motor:
a) Use a large screwdriver or a 13 mm
socket, and remove the cap nut (clock-
wise) from the convection fan, then pull
the fan off the convection fan motor
shaft.