Filter
Top Products
10
ASSEMBLING THE FOOD PROCESSOR
Installing the adjustable slicing disc
1
With the work bowl installed, place the
drive adapter on the power shaft of the
base.
2
Holding the adjustable slicing disc by
the 2 finger grips, align the pins on the
adjustable slicing disc adapter with the
L-slots on the disc. Slide the disc down
onto the adapter and turn to engage
the pins in the L-slot.
IMPORTANT: The adjustable slicing disc can only be installed in one direction.
ASSEMBLING THE FOOD PROCESSOR
Attaching the work bowl cover
1
Place the work bowl cover on the work
bowl with the feed tube just to the left
of the work bowl handle. Grasp the feed
tube and turn the cover to the right until
it locks into place.
2
Fit the food pusher into the 3-in-1
feed tube. See “Using the 3-in-1 Feed
Tube” for details on working with
different sized foods.
NOTE: Be sure to install the desired accessory before attaching the work bowl cover.
NOTE: Your Food Processor will not
operate unless the work bowl and work
bowl cover are properly locked on the
base, and the large pusher is inserted to
the maximum fill line on the feed tube
(approximately halfway down).