24
3. Pull up glass on front of backguard.
4. Grasp both ends of the fluorescent tube.
5. Turn the tube 90° in either direction until both ends come out
of the receptacles.
6. Replace tube and replace top of the control panel.
7. Plug in range or reconnect power.
To Replace Starter:
1. Unplug range or disconnect power.
2. Remove tube.
3. Push starter in and turn approximately 90° counterclockwise.
4. Pull starter out of recessed area.
5. Replace starter, tube and top of control panel.
6. Plug in range or reconnect power.
Oven Light(s)
The oven light(s) is a 40-watt appliance bulb. The light(s) will
come on when the oven door is opened. The light(s) will not work
during the Self-Cleaning cycle. When the oven door is closed,
press OVEN LIGHT to turn the light(s) on or off.
To Replace:
Before replacing, make sure the oven is off and cool.
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Plug in range or reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if necessary, follow these instructions. The oven
door is heavy.
To Remove:
1. Open oven door to the stop position (open about 4 in. [10
cm]).
2. Lift door slightly and pull out and back until hinges come out
to the catch position.
3. Push door down and pull straight out to remove door
completely.
To Replace:
1. Hold oven door by the handle and place the top of the door
under the cooktop overhang.
2. Use front of leg to apply pressure to slide hinges into the slots
as far as possible.
3. Use side of leg to apply pressure to the bottom of the door
front.
4. Lift door slightly. Apply pressure and push until the hinges
have gone in fully.
Storage Drawer
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull drawer straight out to the first stop.
2. Lift up the back of the drawer and pull out.
To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.
4"
4" (10 cm)