Filter
Top Products
G
eneral Information
1. Lay carton on rear face and break open
bottom flaps.
2. Set carton upright with all four
flaps outward.
3. Lii carton up and off of machine.
4. Remove all tape and packaging
materials from the outside and inside
of the cabinet.
5. Remove the lower access panel by
removing the two screws securing the
grille at the bottom and the one screw at
the top, and lift it free of cabinet.
6. Turn the fan by hand to make certain it
moves freely.
7. Loosen thumb screws holding cutter grid
and water pan to “thumb tight.”
8. Replace the lower access panel and
the screws.
- Open bottom flaps
Utilities
(observe local codes)
Each installation is unique but will
require:
1.
A cold water inlet of W (6 mm) OD soft
copper tubing and a shut-off valve.
2. A properly grounded 115 Volt, 60 Hz.,
AC only, 15 or 20 ampere electrical
circuit, installed in accordance with the
National Electrical Code and with local
codes and ordinances.
3. Either a gravity drain system or a sump
pump to lift the water to an existing drain.
Electricity
Drain
4