Filter
Top Products
F
or the Plumber
Connect to water
(observe local codes)
1. Use W (6 mm) OD soft copper tubing for
the cold water supply.
2. Provide a convenient manual shut-off
valve in the water line.
3. Position the tubing so it can enter the
access hole located in the right hand rear
of the cabinet. The tubing should extend
beyond the cabinet front when the
cabinet is pushed back into position.
NOTES:
Always purge the water line before making
the final connection to the inlet of the water
valve to prevent possible water valve
malfunction.
After the cabinet is in place, bend the tubing
to meet the connection at the water valve.
The garden hose threaded compression
fitting is found in the parts bag. This joint
provides a convenient disconnect for
service. Be sure the tubing is clear of
compressor to prevent rattle.
RIGHT END VlEW
W (19 mm)
Water
inlet
solenoid
valve
Hole for
field-
supplied
water line
I.
run to open
(yY$&L2;~
v-+$yT standpipe
Lm ‘-- - m)
(a mm)
. ,ra ml
BACK VIEW BACK VIEW
17%’ 17%’
6