Filter
Top Products
5
To replace top grille:
1.
Insert top grille hooks (located on the back of the top grille)
into the slots on the side trim.
2.
Pull grille down slightly to lock into place.
Architect
®
Series
To remove top grille:
1.
Grasp both ends of louver panel. Push louver panel straight
up, then pull straight out. Lay the panel on a soft surface.
2.
Grasp both ends of the top grille. Push top grille straight up,
then pull straight out. Lay the top grille on a soft surface.
To replace top grille:
1.
Insert top grille hooks (located on the back of the top grille
panel) into the slots on side trim. Pull grille down slightly to
lock into place.
2.
Insert louver panel hooks (located on the back of the louver
panel) into the slots on the side trim. Pull panel down slightly
to lock into place.
Pro Line
TM
Series
To remove top grille:
1.
Grasp both ends of the top grille.
2.
Push the top grille straight up, and then pull straight out.
3.
Disconnect the wiring harness from the back of the top grille.
4.
Lay the assembly on a soft surface.
5.
Place wiring on the top of the cabinet, ensuring it is out of the
way of the doors.
To replace top grille:
1.
Reattach wiring harness into grille back.
2.
Insert top grille hooks into slots on the side trim. Pull grille
down slightly to lock into place.
Turning Power On or Off
1.
Remove top grille.
2.
Press main power switch to the ON or OFF position.
3.
Replace top grille.
IMPORTANT:
Be sure the power switch is set to the ON position
after cleaning refrigerator or changing light bulbs.
Water System Preparation
Please read before using the water system.
Immediately after installation, follow the steps below to make
sure that the water system is properly cleaned.
1.
Open the freezer door and turn off the ice maker. For
Style 1
lift up the wire shutoff arm as shown. For
Style
2
move the
switch to the OFF (right) setting as shown. The ON/OFF
switch is located on the top right side of the freezer
compartment.
Style 1
Style 2
NOTES:
■
If your model has a base grille filter system, make sure the
base grille filter is properly installed and the cap is in the
horizontal position.
■
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
2.
Use a sturdy container to depress the water dispenser bar
until the water begins to flow. Flush the water system by
dispensing and discarding 2 to 3 gal. (8 to 12 L) of water.
Cleaning the system will take approximately 6 to 7 minutes
and will help clear air from the line. Additional flushing may be
required in some households.
NOTE:
As air is cleared from the system, water may spurt out
of the dispenser.
3.
Open the freezer door and turn on the ice maker. For
Style 1
lower the wire shutoff arm. For
Style 2
move the switch to the
ON (left) position. Please refer to the “Ice Maker and Storage
Bin/Bucket” section for further instructions on the operation
of your ice maker.
■
Allow 24 hours to produce the first batch of ice.
1. Top grille
2. Cabinet side trim
3. Louver panel
1. Power On/Off switch
1