Filter
Top Products
7
Cabinet Dimensions
Countertop Cutout Dimensions
IMPORTANT: Countertops with a bull-nosed front edge are not recommended for these installations.
Some models require a countertop deeper than 25" (63.5 cm); see the following Countertop Cutout Dimensions Chart.
To avoid mistakes, it is recommended that the cooktop and vent cutouts be drawn on the countertop before making any cutouts.
See Cooktop Installation Instructions for complete cutout dimensions, location dimensions and installation details.
Interior-mounted blower motor model Exterior-mounted blower motor model
NOTES:
■ See cooktop manufacturer’s instructions for cooktop cutout
depth and width.
■ Use dimensions for vent system cutout location that applies
to your installation.
■ Interior-mounted blower systems connect with 3¹⁄₄" x 10"
(8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent
system. The cutout locations for this vent system will
depend on your specific installation.
NOTES:
■ See cooktop manufacturer’s instructions for cooktop cutout
depth and width.
■ Exterior-mounted blower systems connect with 10" (25.4 cm)
round vent. The cutout locations for this vent system will
depend upon your specific installation.
A.Downdraft vent
B.Cooktop
C.Measurement of cooktop rear overhang.
D.D = Measurement of cooktop rear overhang
(C) + 1
¹³⁄₁₆
" [46.2 mm] (E)
E.1
¹³⁄₁₆
" (46.2 mm)
F. ½" (12.7 mm) minimum
G.¼" (6.4 mm) minimum
H.Countertop and backsplash
I.½" (12.7 mm) minimum
A= ¹⁄₂" (12.7 mm)
minimum
21⁵⁄₁₆"
(54.1 cm)
Cutouts are
for 3¹⁄₄" x 10"
(8.3 x 25.4 cm)
rectangular or 6"
(15.2 cm) round
vent system.
Centerline of cooktop cutout
21⁵⁄₁₆"
(54.1 cm)
Locate power
supply junction
box at lower
left hand
rear corner
of the cabinet.
10" (25.4 cm)
¹⁄₂" (12.7 mm)
minimum
Locate power
supply junction
box at lower
left hand
rear corner
of the cabinet.
A
B
C
E
H
D
I
G
F