Filter
Top Products
11
For non-vented (recirculating) installations only
4. Snap vent grids into openings in lower chimney.
Complete Installation
1. Replace grease filters. See the “Range Hood Care” section.
2. Check the operation of the range hood fan and light. See
“Range Hood Use” section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect power and check wiring connections.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Control Panel
The range hood controls are located on the right-hand front
surface of the range hood.
Operating the Light
1. Press the light button (F) to turn on the light.
2. Press the light button (F) to turn off the light.
Operating the Night Light
1. Press the night light button (G) to turn on the night light.
2. Press the night light button (G) to turn off the night light.
Operating the Fan and Adjusting Fan Speed
The fan has 4 speeds: 1 (low), 2 (medium), 3 (medium-high), and
4 (high).
1. Press the On/Off button (A) to turn the fan on. The speed
setting will appear in the display.
2. Press the “plus” (+) or “minus” (-) buttons to increase or
decrease the fan speed.
3. Press the On/Off button (A) to turn off the fan.
10-Minute Boost Function
Press the “H” button to start the 10-minute boost function. The
fan motor will run on its highest speed (4) as the display counts
down from 10 minutes. At the end of 10 minutes, the fan will
return to the previously selected speed.
Reset Filter Alert
After 100 hours of use, “C” will appear in the range hood display.
This “C” indicates that the filter must be cleaned. ”C” will appear
only when turning off the range hood fan.
Reset Alarm Display
1. Turn off the range hood fan and light.
2. Press the “plus” (+) button for 4 seconds. The “C” will
disappear from the display, and the counter will reset to “0.”
Thermal Protector
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
press the on/off button to turn off the range hood. Wait
approximately 60 minutes, then press the on/off button to restart
the range hood.
A.2 mounting screws
B.Vent grids (for non-vented installations)
A
B
A.Fan motor on/off
B.Decrease fan motor speed
C.Increase fan motor speed
D.Electronic display
E.10 minute timed boost
F. L ight
G.Night light
ABCDEFG