Filter
Top Products
8
INSTALLATION INSTRUCTIONS
Prepare Location
■ It is recommended that the vent system be installed before
hood is installed.
■ Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
■ Check your ceiling height and the hood height maximum
before you select your hood.
1. Disconnect power.
2. Determine which venting method to use: roof, wall, or non-
vented.
3. Select a flat surface for assembling the range hood. Place
covering over that surface.
4. Using 2 or more people, lift range hood onto covered surface.
Tip the hood on its back and remove filters and set aside. See
“Range Hood Care” section.
Range Hood Mounting Screws Installation
1. Determine and mark the centerline on the wall where the
range hood will be installed.
Based on the ceiling or soffit height, determine the distance
“X” (30" [76.2 cm] min, suggested 36" [91.4 cm] max) needed
between the cooking surface and the bottom of the range
hood. To this distance, add 15¹⁄₈" (43.8 cm) and draw a
horizontal line (A) about 24" (61.0 cm) long centered on the
vertical centerline (B) at this distance.
2. Mark 2 points on each side of the horizontal line
4⁹⁄₁₆" (11.6 cm) from the vertical centerline.
3. Drill ³⁄₃₂" (2.4 mm) pilot holes for installation into wood. The
screws provided are for mounting the range hood into wood.
Mounting into drywall or plaster is not recommended.
4. Install 2 - #10 Phillips head mounting screws. Leave a
¹⁄₄" (6.4 mm) gap between the wall and the back of the screw
head to slide range hood into place.
Chimney Support Bracket Installation
1. Place one of the chimney brackets against the wall so that its
top edge is ¹⁄₁₆" (2.0 mm) from the ceiling or soffit and level.
Align the center notches of the bracket and the centerline.
Mark the centers of the bracket holes.
2. Place the other chimney bracket on the wall so that its lower
edge is 16³⁄₁₆" (41.1 cm) from the ceiling or soffit and level.
Align the center notches of the bracket and the centerline.
Mark the centers of the bracket holes.
A.Horizontal line
B.15
¹⁄₈
" (43.8 cm)
C.Distance “X” (30" [76.2 cm] min,
suggested 36" [91.4 cm] max)
D.Vertical centerline
E.Cooking surface
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A
B
C
D
X
E
A.Horizontal line
B.Vertical centerline
C.4
⁹⁄₁₆
" (11.6 cm)
A.Vertical centerline
B.Center notches
C.
¹⁄₁₆
" (1.6 mm)
A
B
C
¹⁄₄"
(6.4 mm)
A
B
C
16³⁄₁₆"
(41.1 cm)