Filter
Top Products
7.4.5 Brewing unit
Push the drip safeguard device onto the AromaControl knob and remove the drip tray located
underneath to clean the brewing unit. Open the service flap – the push button is on the left-hand side
behind the cover. Push the lever marked PUSH located on the brewing unit and pull the brewing unit
towards you. Insert the key enclosed into the top of the brewing unit and turn it carefully anti-
clockwise to remove the top sieve. Rinse everything under running water without any detergent.
When subsequently re-asssembling the unit install the sieve and the brewing unit in reverse order.
Do not press the lever marked PUSH. Close the service flap again.
Care and maintenance
Brewing unit
` Slide the drip safeguard onto the
Aromacontrol device
` Press PUSH and pull the brewing
unit towards the front
` Replace the sieve and the
brewing unit in reverse order
` Remove the drip tray ` Insert the key and remove the top
sieve by turning it anti-clockwise –
be very careful when using the
key
` Do not press PUSH when
assembling the parts
` Open the service flap (push
button behind the cover)
` Clean / dry everything
` Close the brewing unit service
flap
Training manual Section 7 – Page 32
Coffee machines