Filter
Top Products
KGCT 907.2E 23
Installation
Installation in a fitted kitchen
■ Be careful during fitting! Do not put or drop edged or pointed tools
(screwdriver etc.) on the glass top!
■ Any cooker hoods or wall cupboards must have a vertical clearance of at
least 650 mm from the hob unit.
■ The appliance must be installed absolutely horizontally.
■ The Küppersbusch built-in oven EEB 9800 / 9600 can be fitted underneath
the zoom-cooking centre KGCT 907.2E.
The cooker is Y-type design, providing overheating protection for surrounding
surfaces (fitted cupboard components). That means, that this appliance can
be placed with its back wall and one side wall next to cupboard or room walls
of any height. The other side wall may only be placed next to a fitted cupboard
of the same height at the most.
The plastic coating or veneer must be applied with a heat-resistant adhesive
(100 °C). This adhesive prevents the surfaces from warping or working loose.
- Have you connected the mains lead with the appliance?
- Using 4.2 x16 mm screws, install the supporting rails in horizontal position
on the right and on the left onto the cupboard sides according to measu-
rements.
- Fit in the appliance.
- Fasten the appliance onto the supporting rails using 4.2 x 7 mm srews.
- Seal the appliance on the back and on the two sides with silicon.