Lance-Larkin BE-112 Coffeemaker User Manual


 
7 8
O P E RAT I O N
5. Manual Brew Cycle
To manually start a brew cycle move the slide switch from OFF to ON. If the switch is already in the ON position,
switch it to the OFF position and then back to ON. The brew light will turn on once the cycle has started. If brewer
is cold, the heater will preheat the water before starting the brew cycle. After the selected amount of water is
dispensed, the brew light will remain on for 40 seconds. At that time the BREW EXPRESS™ will beep five times.
6. Automatic Brew Cycle
To automatically start a brew cycle set the automatic brew clock. Hold down the program button and press the
minute / hour buttons until the desired time (am or pm) is displayed. Slide switch to the auto position. Place carafe
or mug into the BREW EXPRESS™ under brew basket. The brew cycle will start automatically at the preset time.
NOTE: AUTOMATIC BREW CYCLE WILL NOT START IF THE CARAFE OR MUG ARE NOT PROPERLY IN PLACE.
7. Pause-N-Brew Feature
The BREW EXPRESS™ carafe can be removed during brew cycle to pour a cup of coffee. The detection sensor will
stop the flow of water and the valve on the brew basket will prevent existing water from spilling. Once carafe is
returned operation will continue. If carafe is missing for over 5 minutes BREW EXPRESS™ will shut off automatically.
8. Outlet
The maximum current rating for the outlet is 15 amps. The outlet does not work during the brew process.
Cleaning
Carafe
Clean the carafe and lid after each use with warm water and a mild dish soap.
Brew Basket
The brew basket should also be cleaned after each use with mild dish soap and warm water.
The brew basket is dishwasher safe (top rack only).
Spray Head
It is recommended the spray head be cleaned occasionally with mild soap and warm water depending
on the amount of use. When the unit is cool, remove the spray head by gently rotating it by hand counter
clockwise. After cleaning reinstall the spray head, hand tighten only. Be careful not to damage spray head.
Brewer Exterior
Clean the exterior of the brewer with a soft damp cloth. Avoid getting excessive water around the
display panel and detection sensor. DO NOT use abrasive cleansers, they will damage the surface
of the brewer. Be careful when using stainless cleaner or polish around plastic parts.
Removing Brewer from Wall
If brewer must be removed from wall for repair or cleaning. Follow this procedure.
1. Place cardboard or towel on counter in front of brewer to protect counter surface.
2. Remove screws (4) from the sides of brewer.
3. Firmly grab side edges of brewer with both hands and gently pull straight forward
until brewer moves approximately 1”.
4. Gently rotate the left side of brewer (display panel side) away from the wall until
there is sufficient room to reach inside the rough-in-box.
5. Carefully reach behind brewer and disconnect the water supply line by pressing
on the gray button on the connector from the water line to the brewer.
For more assistance call (866) 268-5953. Also, there is a video for removing the brewer on the Lance Larkin website.
M A I N T E NA N C E