Filter
Top Products
28
BEFORE CALLING FOR SERVICE
TROUBLESHOOTING
Problem Possible Causes Solutions
appears in the • Control pad was touched too long. • This message will appear if any pad except the Timer
timer display or pads is touched for more than 10 seconds.
It will also appear if liquids or objects are spilled or left
on the controls area. To clear the error code, remove any
liquid or objects from the controls area and press the
POWER pad to reset the cooktop.
appears in the •
Supplied voltage to cooktop is • If the voltage of the power supplied to the cooktop is too
timer display too low. low, it cannot operate properly and will show this error
code. This may be caused by reduced voltage being
supplied to the house circuit. If connections are
correct and the supplied voltage returns to normal,
the code will disappear.
appears in the • Electronics fault error message. • Turn the cooktop OFF; then shut off power at the fuse or
display and a number circuit breaker for about 30 seconds. Turn power back
appears in the timer on to the cooktop and turn the cooktop on using the
display POWER pad. If the error message is still displayed, call
for service.
flashes in the • Power outage or initial startup. • When the cooktop is first turned on or after a power
display outage, will blink in the display for 90 minutes or
until the POWER pad is touched for 2 seconds.