Filter
Top Products
LDF9810ST DISHWASHER
LDF9810ST Page 8 DISHWASHER
INSTALLATION
Installation is covered briefly for the servicer who may need to uninstall and
reinstall the dishwasher for repairs. For new installations, please refer to the
installation guide that was supplied with the dishwasher.
• We recommend a location as close to the sink as possible (but not directly
under it) for easy connection to water and drain lines.
• The installation must be within 10’ (3 m) of the sink for proper drainage.
• If the dishwasher is installed in a corner (next to an adjacent wall), there
must be 2” (50 mm) clearance.
• The floor under the dishwasher should be at the same level as the rest of
the room so the dishwasher can slide in and out easily for service.
Drill a 1½” hole on either side to allow
for the drain hose, water supply hose,
and electrical cable. The opening must
be in an area within 4” (100 mm) of the
back wall and 4” (100 mm) of the floor.
If there is a floor in the cabinet under
the sink, it will be necessary to cut
through it to connect the water, drain,
and electrical cable under the sink.
The dishwasher must be supplied with
120 V
AC
60 Hz 1Ø current as indicated
on the rating plate and connected to a
properly fused and grounded dedicated
20-amp circuit.
The wire or water supply can be fed
from either side, and both from the
same side, depending upon source
location.
They must be run in the channels
under the dishwasher, as shown in the
drawing.