Filter
Top Products
LDF9810ST DISHWASHER
LDF9810ST Page 9 DISHWASHER
ELECTRICAL SUPPLY PREPATATION
The dishwasher can be hardwired if necessary and if permitted by local code. We
recommend the use of a dishwasher installation kit, available at most hardware
and home supply stored. This kit includes a cordset, a flexible water supply line,
and the elbow connector necessary to connect it. Using a cordset requires an
electric outlet under the sink accessible when the dishwasher is installed. The
cordset makes it easier to disconnect the dishwasher from power while working
on it and makes removal and replacement easier. As stated earlier, installation
requires a properly fused and grounded dedicated circuit.
WATER SUPPLY PREPARATION
The dishwasher may be connected to either hot or cold water. If the hot water
can not maintained below 149° F, the dishwasher must be connected to the cold
water supply. Lay out the water supply line as indicated on page 14 of this
training manual. Use sealing tape or joint compound to avoid leaks.
INSTALLATION
Adjust the legs to the required height
for the dishwasher to slide under the
countertop and be level. Check the
level using a spirit level.
Attach the leveling feet kit to allow for
fine tuning when the dishwasher is
pushed into place.
To complete the installation:
Remove the lower cover.
Make sure the legs are adjusted and
the dishwasher is level.
Lay out the electrical cable, water
supply tube, and drain hose as
shown.
Slide the dishwasher carefully back
into place.
Make the appropriate connections, as
directed below.