Filter
Top Products
LDF9810ST DISHWASHER
LDF9810ST Page 10 DISHWASHER
DRAIN CONNECTION
The drain hose must be connected in a manner that meets the local plumbing
code. If the end of the drain hose does not fit the available connector, an adapter
may be obtained from a local hardware or plumbing supplier.
The rubber end can be cut off for the
correct size attachment.
See supplementary drain information on
page 50 of this training manual.
This drawing shows the drain line
installed with a rise in the drain pipe
but no air gap. It can also be with an
air gap installed. Be sure to observe
the clearances listed.
Most garbage disposers have a
dishwasher drain fitting built in to
them. If your installation does not
include a disposer, you can use a
special tail piece with a drain
attachment available at most
hardware and home supply stores.
WATER CONNECTION
Turn off the water supply and connect
the elbow to the inlet valve.
Connect the flexible supply tube to the
elbow.
Use sealing tape to make all
connections.
Make sure the supply line is not kinked.
ELECTRICAL CONNECTION
Use wire
connectors and
replace the
cover on the
junction box.
(12/2 w/ ground,
20-amps)