Filter
Top Products
13 INSTALLATION
Removing/Assembling the
Freezer Drawer Handle
Removing the Handle
1
Loosen the set screws located on the
lower side of the handle with a
1
/
8
in. Allen
wrench and remove the handle.
2
Loosen the mounting fasteners that
connect to the
freezer drawer
and handle
using a
1
/
4
in.
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handle
1
Assemble the mounting fasteners at
both ends of the handle using a
1
/
4
in. Allen
wrench.
2
Place the handle on the door by tting the
handle
footprints over
the mounting
fasteners and
tightening the
set screws
with a
1
/
8
in.
Allen wrench.
Removing/Assembling the
Doors and Drawers
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
is the recommended procedure.
WARNING
When assembling or disassembling the
handle:
Grasp the handle tightly to avoid drop-
ping it.
Do not swing the handle into nearby
people or animals.
Make sure that the bracket hole of the
handle ts properly into the stopper
bolt of the door. Assemble the set
screws to x the handle into place.
Make sure that there is not a gap
between the door and handle after
assembling the handle.
WARNING
If your entrance door is too narrow
for the refrigerator to pass through,
remove the refrigerator doors and move
the refrigerator sid eways through the
doorway.
Use two or more people to remove and
install the refrigerator doors. Failure to
do so can result in back or other injury.
Disconnect the electrical supply to the
refrigerator before installation. Failure
to do so could result in serious injury or
death.
Do not put hands, feet or other objects
into the air vents or bottom of the
refrigerator. You may be injured or
receive an electrical shock.
Be careful when handling the hinge and
stopper. You may be injured.
Remove food and bins before detaching
the doors and drawers.
ENGLISH