Filter
Top Products
26HOW TO USE
HOW TO USE
Before use
Clean the refrigerator.
Clean your refrigerator thoroughly and wipe o all dust that accumulated during
shipping.
Connect the power supply.
Check if the power supply is connected before use.
Read the “Turning On The Power” section.
Turn off the icemaker if the refrigerator is not yet connected to
the water supply.
Turn o the automatic icemaker and then plug the power plug of the refrigerator
into the grounded electric outlet.
* This is applicable only to certain models.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food
in it. Check the ow of cold air in the freezer compartment to ensure proper
cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature lowers.
Open refrigerator doors and freezer drawers to ventilate the interior.
The inside of the refrigerator may smell like plastic at rst. Remove any adhesive
tape from inside the refrigerator and open the refrigerator doors and the freezer
drawers for ventilation.
CAUTION
Running the automatic icemaker before connecting it to the water supply
may cause the refrigerator to malfunction.
CAUTION
Putting food in the refrigerator before it has cooled could cause the food to
spoil, or a bad odor could remain inside the refrigerator.
CAUTION
Do not scratch the refrigerator with a sharp object or use a detergent that
contains alcohol, a ammable liquid or an abrasive when removing any
tape or adhesive from the refrigerator,.
Do not peel o the model or serial number label or the technical
information on the rear surface of the refrigerator.
NOTE
Remove adhesive residue by wiping it o with your thumb or dish detergent.
ENGLISH