LG Electronics LFC24770SW Refrigerator User Manual


 
41 TROUBLESHOOTING
snoituloSsesuaC elbissoPmelborP
Icemaker is not
making enough
ice (continued).
Refrigerator was recently
installed or icemaker
recently connected.
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker
to begin making ice.
Icemaker not turned on. Locate the icemaker ON/OFF switch and conrm
that it is in the ON (I) position.
The ice detecting sensor is
obstructed.
Foreign substances or frost on the ice-detecting
sensor can interrupt ice production. Make sure
that the sensor area is clean at all times for proper
operation.
The refrigerator is not
connected to a water
supply or the supply shuto
valve is not turned on.
Connect the refrigerator to the water supply and
turn the water shuto valve fully open.
Icemaker shuto (arm or
sensor) obstructed.
If your icemaker is equipped with an ice shuto
arm, make sure that the arm moves freely. If
your icemaker is equipped with the electronic ice
shuto sensor, make sure that there is a clear
path between the two sensors.
Reverse osmosis water
ltration system is
connected to your cold
water supply.
Reverse osmosis ltration systems can reduce
the water pressure below the minimum amount
and result in icemaker issues. (Refer to the Water
Pressure section.)
Ice has bad
taste or odor.
Water supply contains
minerals such as sulfur.
A water lter may need to be installed to eliminate
taste and odor problems. NOTE: In some cases,
a lter may not help. It may not be possible
to remove all minerals/odor/taste in all water
supplies.
Icemaker was recently
installed.
Ice that has been stored for too long will shrink,
become cloudy, and may develop a stale taste.
Throw away old ice and make a new supply.
The food has not been
stored properly in either
compartment.
Rewrap the food. Odors may migrate to the ice if
food is not wrapped properly.
The interior of the
refrigerator needs to be
cleaned.
See the Care and Cleaning section for more
information.
The ice storage bin needs
to be cleaned.
Empty and wash the bin (discard old cubes).
Make sure that the bin is completely dry before
reinstalling it.
Icemaker is
making too
much ice.
Icemaker shuto (arm/
sensor) is obstructed
Empty the ice bin. If your icemaker is equipped
with an ice shuto arm, make sure that the arm
moves freely. If your icemaker is equipped with
the electronic ice shuto sensor, make sure that
there is a clear path between the two sensors.
Reinstall the ice bin and wait 24 hours to conrm
proper operation.
ENGLISH