Filter
Top Products
EXPLOSION HAZARD
Do not use flammable cleaners. Not following these
instructions can cause death, explosion or fire.
The refrigerator, as well as the freezer, do their own
de-freezing. This process does not prevent the build
up of contaminants, therefore it is suggested that you
clean both parts once a month; clean spilled liquids
immediately.
BACK COVER
ELECTRICAL SHOCK HAZARD
Before you begin, either unplug the refrigerator or turn
off power at the circuit breaker or fuse box.
NOTE: Back Cover should only
be removed by a qualified
technician.
In order to get an efficient
performance of your refrigerator,
clean the back cover of it at least
twice a year.
REFRIGERATOR CLEANING
• Unplug your refrigerator.
• Pull out all of the removable parts (such as the
vegetable and dairy doors).
• Use a clean sponge (or a soft rag) and use it with
lukewarm water mixed with detergent. Do not use
abrasive or concentrated cleaners.
• Hand wash it, and dry it thoroughly.
• Plug the refrigerator back in.
OUTSIDE
Wax the outside in order to create better protection. Make
sure you use a product specifically design to be used
for electro-domestic products (car wax is acceptable).
Use a clean, soft rag, and perform this task twice a year.
For metal-made refrigerators, do not wax, simply clean
it with water and detergent. Do not use concentrated or
abrasive products.
NOTE: Avoid the usage of chemical products that
contain phosphates or bleach.
INSIDE (Allow freezer to slightly warm up a small
degree to prevent cloth from sticking)
In order to eliminate bad odors, clean the inside of
the refrigerator with a mixture of baking powder and
lukewarm water (one teaspoon of baking powder per cup
of water). Ensure that the powder dissolves thoroughly, in
order to prevent any sort of damage.
DOOR LINING AND GASKETS
Use only a mild detergent (such as dish soap).
PLASTIC PARTS (Covers and Panels)
Do not use abrasive, paper or rough products. These
could damage the product.
REPLACING REFRIGERATOR LIGHTS
NOTE: The interior lighting for refrigerator uses LED
lighting.
DO NOT try to change any LED module. LED lighting
should only be replaced by a qualified service technician.
REPLACING FREEZER LIGHTS
ELECTRICAL SHOCK HAZARD
Before replacing a burned-out light bulb, either
unplug the refrigerator or turn off power at the circuit
breaker or fuse box.
NOTE: Moving the control to the OFF position does
not remove power to the light circuit.
1. Unplug refrigerator power cord form outlet.
2. Use a screwdriver to remove the cover screw. (Save
the cover screw)
3. Using a flat instrument, gently pry the lamp cover
loose in the front as shown. Rotate downward to
remove the rear tabs.
4. Make sure the bulb is cool to the touch. Turn the
bulb counterclockwise to remove.
5. Replace with a new 60-watt appliance bulb.
6. Insert tabs on back of cover into slots in freezer
ceiling. Push cover up to snap front into place.
7. Use a screwdriver to assemble the cover screw.
CAUTION
DO NOT place fingers inside of cover.
Lamp may be hot.
21