Filter
Top Products
HOW TO CONNECT ELECTRICITY
IMPORTANT: Please read carefully.
WARNING
Electrical Shock Hazard
For personal _fety, this appliance must
properly ground_. Have the wall outlet and
the circuit checked by a qualified el_triclan to
make sure the outlet is properly grounded.
RECOMMENDED GROUNDING METHOD
The refrigerator should always be plugged into
its own individual properly grounded electrical
outlet rated for 120 volts, 60 Hz, AC only, and
fused at 20 amperes.. This provides the
best performance and also prevents overloading
house wiring drcuits which could cause a fire
hazard from overheated wires. It is
recommended that a separate circuit serving
only this appliance be provided..
Use a re_ptacle which cannot be turned off with
a switch or pull chain. Do not use an extension
cord. Where a standard twooprong wall outlet is
encountered, it is your personal responsibility
and obligation to have it replaced with a properly
grounded three-prong wall outlet..
Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord,
Do not use an adapter plug,
NOTE: Some models have LED interior lighting and
service should be performed by a qualified technician..
When you are finished, reconnect the refrigerator to
the electrical source and reset the control
(Thermostat, Refrigerator Control, or Freezer Control,
depending on the model) to the desired setting.
USE OF EXTENSION COR_
B_ause of _tential safety hazards under
certain conditions, we strongly recommend
against the use of an extension cord,
However, if you still elect to use an extension
cord, it is absolutely necessary that it be a UL-listed
(USA), 3owire grounding-type appliance
extension _rd having a grounding-type plug
and outlet and that the electrical rating of the
cord be 20 amperes (minimum) and 120 volts_
Use of an extension cord will increase the
clearance needed for the back of the
refrigerato r.
NOTE: Before performing any type of installation,
cleaning, or removing a light bulb, turn the control
(Thermostat, Refrigerator Control or Freezer Control,
depending on the model) to OFF and then disconnect
the refrigerator from the electrical source_ When you
are finished, reconnect the refrigerator to the
electrical source and reset the control (Thermostat,
Refrigerator Control or Freezer Control, depending on
the model) to the desired setting.
SAVE THESE INSTRUCTIONS
5