Filter
Top Products
FLOORING
To minimize noise and vibration, the refrigerator
MUST be installed on a solidly constructed
floor.
To avoid vibration, the unit must be level. If
required, adjust the leveling legs to compensate
for unevenness of the floor. The front should be
slightly higher than the rear to aid in door
closing. The leveling legs can be turned easily
by pushing against the top of the refrigerator to
take the weight off the feet. Turn the leveling
legs clockwise to raise the unit or
counterclockwise to lower it.
• Carpeting and soft tile surfaces are not
recommended.
• Never install the refrigerator on a platform or
weakly supported structure.
NOTE: When moving the refrigerator for cleaning
or service, be sure to protect the floor. Always
pull the refrigerator straight out when moving it.
Do not wiggle or walk the refrigerator when trying
to move it; floor damage could occur.
NOTE: It is recommend that the doors be removed when it is necessary, to move the refrigerator through a
narrow opening.
HANDLE REMOVAL
To move the refrigerator through a house door, it
may be necessary to remove the refrigerator
door handles,
NOTE: Handle appearance may vary from
illustrations on this page,
• Use special care when removing handles to
prevent scratching the doors,
• The handle could be damaged if you hit it with
a hammer while removing or attaching.
• When you assemble or disassemble a handle,
you must push or pull with reasonable force.
Fasteners
Set Screw
Allen Wrench
Loosen the set screws with a 2,5 mm (3/32")
Allen wrench and remove the handle.
NOTE: if the handle mounting fasteners need
to be tightened or removed, use a 1/4" Alien
wrench.
Loosen the set screws located on the iower
side of the handle with a 3.1 mm (1/8") Aiten
wrench and remove the handle.
NOTE: If the handle mounting fasteners ne_
to be tightened or remove, use a 1/4" Ailen
wrench.
9