Filter
Top Products
-16-
E. AIR GUIDE REMOVAL (Figure 12)
(1) Separate cavity and base plate.
(2) Unfasten the screws which hold the air guide in the
base plate.
(3) Unfasten the air guide from hook.
F. POWER BOARD AND INVERTER MODULE AND
SUCTION GUIDE (Figure 12)
(1) Separate cavity and base plate.
(2) Remove air guide.
(3) Unfasten the screws.
(4) Lift up the power board, inverter module and suction
guide.
G. SENSOR DUCT REMOVAL (Figure 13)
(1) Remove out case.
(2) Unfasten the sensor duct screw.
(3) Disconnect sensor lead wire.
(4) Pull the sensor duct out.
Figure 12
Figure 13