Filter
Top Products
J
. FAN MOTOR ASSEMBLY REMOVAL
(
1) Separate cavity and base plate.
(
2) Remove air and suction guide..
(
3) Remove the two screws holding the fan motor
ASSEMBLY
to the suction guide
ASSEMBLY
.
(
4) Disconnect the wires and unfasten the screws.
(
5) Pull out the Fan motor from the suction guide.
K. INTERLOCK SYSTEM
(1) INTERLOCK MECHANISM
The door lock mechanism is a device which has been
specially designed to eliminate completely microwave
activity when the door is opened during cooking and thus
to prevent the danger resulting from the microwave
leakage.
(2) MOUNTING OF THE PRIMARY/MONITOR/
SECONDARY SWITCHES TO THE LATCH BOARD
(3) INSTALLATION AND ADJUSTMENT OF THE LATCH
BOARD TO THE OVEN ASSEMBLY
• Mount the latch board to the oven assembly.
• Adjust the latch board in the arrow direction so that oven
door will not have any play in it when the door is closed.
• Tighten the mounting screw.
• Check for play in the door by pushing the door
release button. Door movement should be less than
0.5 mm. (1/64 inch)
Don't push the door release button while making this
adjustment. Make sure that the latch moves smoothly after
adjustment is completed and that the screws are tight.
Make sure the primary, monitor, and secondary switches
operate properly by following the continuity test procedure.
-18-
Suction
Guide
Fan Motor ASS’Y
Inverter
Figure 16
PRIMARY
SWITCH
ADJUSTMENT
DIRECTION
MONITOR
SWITCH
SECONDARY
SWITCH
Figure 17