Filter
Top Products
Self Diagnostics Failure Code
- 19 -
This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODE
F01
F33-34
F44
CAUSE
* Overcooked food
* Temperature of exhausted air is too
high
* Defective sensor circuit
* When a pad was pressed for more than
2 minutes
* Defective pad or control circuit
WHAT TO DO
* Press Stop/Reset Pad to stop
beep.
* Unplug the oven and wait at least
30 minutes before reconnecting.
* Wait for the oven to cool down and reset.
* If a flame is observed, do not open the
oven door.
* If normal operation does not resume,
call the service agent with the
information of failure code.
* Unplug the oven and wait more than
10 seconds before reconnecting.
* If normal operation does not resume,
call the service agent with the
information of failure code.
Care of Your Microwave Oven
1. Unplug the oven before cleaning.
2. Keep the inside of the oven clean. When food
spatters or spilled liquids adhere to the oven walls,
wipe with a damp paper towel. Mild detergent may
be used if the oven gets very dirty. The use of
harsh detergent or abrasives is not recommended.
3. The outside oven surfaces should be cleaned with
a damp paper towel. To prevent damage to the
operating parts inside the oven, water should not
be allowed to seep into the ventilation openings.
4. If the Control Panel becomes dirty, clean it with a
soft, dry cloth. Do not use harsh detergents or
abrasives on the Control Panel. When cleaning the
Control Panel, leave the oven door open to
prevent the oven from accidentally turning on.
After cleaning, press the Stop/Reset Pad to clear
the display window or turn the Timer Select Dial
back to zero “0” position.
5. If steam accumulates inside or around the outside
of the oven door, wipe with a soft paper towel.
This may occur when the microwave oven is
operated under high humidity conditions and in no
way indicates malfunction of the unit.
6. Clean off the grease and dust on bottom surfaces
often. Use warm detergent solution.
7. This oven should only be serviced by qualified
person. For maintenance and repair of the oven
contact the nearest authorized dealer.
NOTE: Above codes shown in the display do not indicate all the possible failures on the unit.