Filter
Top Products
For Your Safety
- 2 -
This appliance is supplied with a moulded three pin
mains plug for your safety and convenience. A 13
amp fuse is fitted in this plug. Should the fuse need
to be replaced, please ensure that the replacement
fuse has a rating of 13 amps and that it is approved
by ASTA or BSI to BS1362. Check for the ASTA
mark or the BSI mark on the body of the
fuse.
If the fuse cover is detachable, never use the plug
with the cover omitted. If a replacement fuse cover
is required, ensure that it is the same colour as
that visible on the face of the plug (i.e. Red or
Orange). A replacement fuse cover can be
purchased from your local Panasonic Dealer.
HOW TO REPLACE THE FUSE
Open the fuse compartment
with a screwdriver and replace
the fuse.
IF THE FITTED MOULDED PLUG IS UNSUITABLE
FOR THE SOCKET OUTLET IN YOUR HOME THEN
THE FUSE SHOULD BE REMOVED AND THE
PLUG CUT OFF AND DISPOSED OF SAFELY AND
AN APPROPRIATE ONE FITTED. THERE IS A
DANGER OF SEVERE ELECTRICAL SHOCK IF
THE CUT OFF PLUG IS INSERTED INTO ANY 13
AMP SOCKET.
If a new plug is to be fitted, please observe the
wiring code as shown to the right above. If in any
doubt, please consult a qualified electrician. (For U.K.
Models only)
WARNING: THIS APPLIANCE MUST BE
EARTHED.
IMPORTANT: The wires in this mains lead are
coloured in accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wire in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured GREEN-AND-YELLOW
must be connected to the terminal in the plug which
is marked with the letter E or by the Earth symbol
or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected
to the terminal in the plug which is marked with the
letter N or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal in the plug which is
marked with the letter L or coloured RED.
Voltage & Power
The voltage used must be the same as specified
on this microwave oven. Using a higher voltage
than that which is specified is dangerous and may
result in a fire or other type of accident causing
damage.
Do not immerse cord, plug or oven in water. Keep
cord away from heated surfaces. Do not let cord
hang over the edge of table or worktop. Do not plug
your oven in via an extension cable as this can be
dangerous. It is important to plug the oven directly
into a wall socket.
The back of the appliance heats up during use. Do
not allow the cord to be in contact with the back of
the appliance or cabinet surface.
ASA
Unpacking Your Oven
1. Examine Your Oven
Unpack the oven, remove all packing material,
and examine the oven for any damage such as
dents, broken door latches or cracks in the door.
Notify dealer immediately if the unit is damaged.
DO NOT install it if the unit is damaged.
2. Guarantee Card
Fill out and post the pre-
addressed guarantee card.
3. Cord
If the supply cord of this
appliance is damaged, it must be replaced by the
special cord available only from the manufacturer.
N.B. The appliance should be inspected for damage
to the door seals and door seal areas and if these
areas are damaged the appliance should not be
operated until it has been repaired by service
technician trained by the manufacturer.
4. Removal of protective film
A protective film is used to prevent scratching of
the outer case during transportation. Peel this film
off before installation or use.
DO NOT REMOVE THE ADHESIVE PLASTIC FILM FROM THE INSIDE OF THE DOOR.
MICROWAVE
Guarantee Card