Filter
Top Products
Liebert iCOM Control—Firmware Version XP1.00.010.STD
58
Figure 64 System/Network Setup screen—System, page 2 of 2
IP Address—Contains the network address of the display. This address must be unique on the
network. The factory default is 192.168.254.003.
Netmask—Defines which part of the IP address is used for the network. The factory default is
255.255.255.000.
Gateway—A network point that acts as an entrance to another network. The factory default is
0.000.000.000.
MAC—A unique hardware identifier for the Ethernet device. The following parameters (U2U
Protocol, U2U Address and U2U Group) are for displaying other networked Liebert XDPs. The
Liebert XDP does not perform Teamwork Operations.
U2U Protocol—This is always set to GBP.
U2U Address—A unique identifier for each display on the network. Display addresses range from 33
to 64. Each display on the U2U network must have a different U2U address. Not currently used.
U2U Group—Used to create zones or groups within a U2U network. Once a group number is
selected, the display will see only other devices with the same group number. The group number can
be changed to view other devices in different groups. Not currently used.
Bootloader Variables—Indicates the bootloader has changed since it was last loaded. This
parameter should only be activated by an authorized service person.
SYSTEM/NETWORK SETUP (page 2 of 2) SYSTEM
Attention: any changes done on these parameters
must be followed by a 'Save+Reboot' command .
PASSWORD (Actual Level 0)
IP Address
Netmask
Gateway
MAC
U2U Protocol
U2U Address
U2U Group
Bootloader Variables
S812
S813
S814
S815
S816
S817
S818
S819
S820
S821
S822
????
192.168.254.003
255.255.255.000
0.000.000.000
00:00:68:19:40:C7
GBP
33
1
NoOK