Filter
Top Products
GB
21
Mounting the dust filter
The supplied dust filter prevents that dirt enters the motor compart-
ment, reducing the refrigeration performance. Therefore always
install the dust filter.
1. Pull the bottom freezer drawer right out.
2. Remove the protective film from the dust filter. Insert the filter at
the bottom, press the button down and click the filter into place.
Mounting the ventilation grille
Important!
To ensure fault-free operation of the appliance, you must
install the supplied ventilation grille.
Do not obstruct the ventilation opening or cover it with a panel!
Mounting the freezer panels
1. Pull out the top freezer drawer and screw on the pre-assembled
panel. The same screws must be used as those used to screw
on the attachment brackets (3.5 x 13).
2. Close the freezer drawer and check the position of the panel.
Adjust the height of the panel by undoing the left and right
screws. Tighten the screws.
3. Pull out the bottom freezer drawer and mount the panel in the
same way.
4. For both drawers, cover the gap between the drawer and the
panel with the cover strips supplied. Remove the protective
film from the trim and insert into the gap at the top.
3.5 x 13 mm
Changing over door hinges
Door hinges should only be changed by a trained expert.
WARNING!
Do not try to change over the door hinges yourself. The
refrigerator door hinges are fitted with strong closing
springs. If the hinge accidentally snaps shut, this can lead
to serious injury.