Filter
Top Products
14
Mounting the anti-tipping device
WARNING!
The supplied anti-tipping bracket must be installed in all
cases. This prevents the appliance from tipping over when
the fully loaded door is opened.
Installation:
1. Mark the centre line of the appliance on the floor.
Align the anti-tipping bracket centre to the centre line.
CAUTION!
Ensure that there are no electric cables or water pipes in the
wall section to which the anti-tipping bracket is to be secured.
These could be damaged during installation.
2. Secure the anti-tipping bracket to the floor using the 3 screws
(6 mm x 60 mm) included in the accessory pack.
The distance between the leading edge of the body of the unit
and the rear edge of the anti-tipping bracket is 610 mm.
Important!
When securing the anti-tipping bracket to a concrete floor,
use suitable plugs!
Wall
Connection to the water supply
Safety instructions and warnings
• Do not connect to the water supply while the combined refrigerator-
freezer is connected to the electricity supply.
• The connection to the mains water supply may only be
made by trained personnel.
• The water quality must comply with the drinking water
directives of the country in which the appliance is used.
• The ice maker is designed exclusively to make ice cubes in
quantities required by a household and may only be operated
with water suitable for this purpose.
• All repairs and work on the ice maker may only be carried out by
customer service personnel or other trained personnel.
• The manufacturer cannot accept liability for damage caused
by a faulty connection to the mains water supply.
Water pressure
The water pressure must be between 0.15 and 0.6 MPa (1.5 -
6 bar).
Important:
If the water filter is inserted in the appliance, the water
pressure must lie between 0.3 and 0.6 MPa (3 - 6 bar).
If the water pressure with the inserted water filter is too low,
this may cause the ice maker to malfunction.
The water supply to the appliance must be through a cold
water pipe that can withstand
the operating pressure and
complies with the hygiene
regulations. For this, use the
stainless steel hose supplied
(length 3 m).
Installation
1. Place the appliance in front of the installation recess.
2. Apply the cover strips to the left and right side walls of the ap-
pliance.
2.
2.