Liebherr 7082 133-00 Refrigerator User Manual


 
12
Connecting to the mains
Power supply (AC) and voltage at the operating point must comply
with the details on the type plate, which is located on the inside
left of the appliance, next to the vegetable bins. The socket must
be fused with a 10 A fuse or higher, it must be away from the rear
of the appliance and must be easily accessible.
Connect the appliance with a properly earthed fused plug
and socket only.
Setting up
• Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level.
• The ventilation grilles should not be obstructed. Always ensure
that there is good ventilation and that the outward flowing air is
able to escape.
• Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m³ per 8 g of R 600a
refrigerant used in the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The
quantity of refrigerant used in your appliance is indicated on the
type plate on the inside of the appliance.
• Do not connect the appliance to the supply with other equipment
using an extension cable - risk of overheating.
Appliance dimensions
Appliance venting
The required air flow is directed through the plinth.
It is important to use the provided ventilation grille for the ventila-
tion opening.
This opening must not be covered.
A = 76 mm
B = 2027 mm
C = 910 mm
D = 610 mm
E = 1556 mm
F = 943 mm
Screw the supplied securing plates on the left and on the
right of the appliance using 3.9 x 11 screws.