Filter
Top Products
19
GN/SGN/es..6
GB
Customer service and type
plate
If none of the above causes apply and you cannot
rectify the fault yourself, or if the temperature display reads
"F 1 " to " F 5", this means that there is a fault. Please
contact your nearest customer service department (see
enclosed list for addresses). Give the fault number dis-
played, together with the
type designation 1,
service number 2 and
appliance number 3
as given on the type plate, fig. A2, so as to ensure rapid, ac-
curate servicing. The type plate is located inside the freezer
compartment on the left-hand side.
Leave the appliance shut until the customer service engi-
neer arrives so as to prevent any further cold loss.
Troubleshooting
Net@Home
1
Depending on the model and equipment, your appliance
may have an additional interface to which you can connect
an optional Net@Home module.
You can choose between a TeleSafe module and a home
bus slave module. The modules are available from your
dealer.
If your appliance has this interface 1, it will be located at
the back of the appliance near the top:
TeleSafe module
The TeleSafe module informs you immediately if your appli-
ance develops a fault.
In the event of a temperature alarm, mains failure or another
fault display (F1 to F5), the fault status is immediately for-
warded to the alarm contact.
The alarm contact can be connected to any of the following
processing units:
- a telephone system with an appropriate signal input,
- an in-house alarm system or building control system,
- an automatic telephone dialling and announcement unit.
In the event of an alarm a programmable number is di-
alled and a recorded message is played back.
Home bus module
The home bus slave module enables you to integrate your
appliance into a home network (EHS Powerline). You can
then
- operate all the functions of the appliance or
- display the status of the appliance, e.g. door open alarm,
current refrigerator/freezer temperature, or
- assemble the Liebherr HomeDialogSystem.
In this way a freezer installed in the basement can be
controlled via the display on the combined refrigerator-
freezer in the kitchen (setting the temperature, switching
SuperFrost or DuraFrost on and off). All display functions
(temperature, door alarm, mains failure) can also be called
up.
For more information, please visit our website at
www.liebherr.com