Liebherr 7083 247-00 Appliance Trim Kit User Manual


  Open as PDF
of 13
 
23
GB
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
itoanddisconnecttheplugorswitchoorunscrewthefuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
Cleaning
Before cleaning always switch o the appliance. Disconnect
from the mains or switch o or unscrew the fuse.
•Cleantheinside,equipmentandouterwallswithlukewarmwater
andalittledetergent.Donotuseabrasiveoracidcleanersor
chemical solvents.
Do not use steam cleaners because of the
risk of injury and damage.
•Ensurethatnocleaningwaterpenetratesintotheelectricalcom-
ponents or ventilation grille.
•Thedustshouldberemovedfromtherefrigerationunitandheat
exchanger - metal grid at the back of the appliance - once a year.
•Donotdamageorremovethetypeplateontheinsideoftheap-
pliance. It is very important for servicing purposes.
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
• Loud running noise:
– Is the appliance set up firmly on the floor?
–Doestheappliancecausenearbyitemsoffurnitureorobjectsto
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
–Doestheseparatelyinstalledthermometershowthecorrectread-
ing?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
•
appearsinthedisplay:
– Reset the real time clock (see "Setting the real time clock").
If none of the above causes
apply and you cannot rectify the
fault yourself, contact the near-
est customer service depart-
ment stating the type designa-
tion
1, service number 2and
appliance number
3 as indi-
cated on the type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.
1.Drillmarkedsectiononthebackof
the appliance.
Opening for external temperature sensor
2. Pull out strain relief device (bot-
tom left of interior container).
3. Feed sensor through opening and
secure sensor cable with strain
relief device.
Important!
Position the sensor at the top of the interior container. The sen-
sor must not come into contact with objects so that only the air
temperature is measured.
Important!
4. Close the sensor cable opening at the back of
the appliance with the sealant provided.
 previous next