Liebherr 7083 247-00 Appliance Trim Kit User Manual


 
25
GB
1. Unscrew the hinge bracket.
Important: The door mounting has
a spring mechanism enabling the
door to close by itself. The hinge
bracket turns to the left when the
screws are undone.
2. Pull the door out at the bottom
andlifto.
3. Transfer handle and plugs to the
opposite side of the door.
4. Transfer pin on hinge bracket to the
opposite side.
5. Transfer upper hinge components to
the opposite side.
6. Transfer cover plate to the opposite
side.
7. Mount door on hinge pin and close.
8. Insert hinge bracket in lower door
mounting.
9. Turn hinge bracket by 90° - spring
is compressed. Screw on hinge
bracket.
Changing over door hinges Installation dimensions (mm)
Version 1
A cross-section of min. 200 cm
2
is re quired in the
worktop for ventilation of the rear of the appliance.
Version 2
If no ventilation grille is provided in the worktop, the recess
must be at least 860 mm high to ensure adequate heat
dissipation to the front.
The appliance complies with the relevant safety regulations and
ECDirectives2004/108/ECand2006/95/EC.