Filter
Top Products
2
Setting up
• Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level.
• The ventilation grilles should not be obstructed. Always ensure
that there is good ventilation and that the outward flowing air is
able to escape.
• Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m³ per 8 g of R 600a
refrigerant used in the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The
quantity of refrigerant used in your appliance is indicated on the
type plate on the inside of the appliance.
Appliance venting
The required air flow is directed
through the plinth.
It is important to use the provided
ventilation grille for the ventilation
opening.
This opening must not be cov-
ered.
Failure to use the supplied grille
can result in product failure and
will void the warranty.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the description of
the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appliance and must
be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating/three-phase cur-
rent) or energy-saving plugs. Risk of damage
to the electronic control system!
Door swing clearance
Please allow for door swing clearance
at locations next to a wall.
The illustrated measurement is with-
out mounted front panels.
Be sure to add your panel thickness
and handle depth to this measure-
ment in order to avoid interferences.
Content Page
Setting up ...................................................................................2
Electrical connection ..................................................................2
Appliance venting .......................................................................2
Door swing clearance .................................................................2
Appliance dimensions ................................................................3
Installation dimensions ...............................................................3
Mounting the anti-tipping device ................................................4
Mounting options ........................................................................4
Connection to the water supply ..................................................5
Leveling the appliance ...............................................................7
Fastening the appliance in the recess ........................................7
Adjusting the refrigerator door ....................................................7
Adjusting the front of the drawer .................................................7
Mounting the ventilation grille .....................................................8
Before fitting the door panels .....................................................9
Panel dimensions .......................................................................9
Mounting the attachment brackets onto the door panels .........10
Mounting the refrigerator panel ................................................11
Mounting the freezer panels .....................................................13
Changing over door hinges ......................................................13