Filter
Top Products
5
3.
4.
Connection to the water supply
Safety instructions and warnings
• Do not connect to the water supply while the combined refrigerator-
freezer is connected to the electricity supply.
• The connection to the mains water supply may only be
made by trained personnel.
• The water quality must comply with the drinking water
directives of the country in which the appliance is used.
• The ice maker is designed exclusively to make ice cubes in
quantities required by a household and may only be operated
with water suitable for this purpose.
• All repairs and work on the ice maker may only be carried out by
customer service personnel or other trained personnel.
• The manufacturer cannot accept liability for damage caused
by a faulty connection to the mains water supply.
Water pressure
The water pressure must be between 0.15 and 0.6 MPa (1.5 -
6 bar).
Important:
If the water filter is inserted in the appliance, the water
pressure must lie between 0.3 and 0.6 MPa (3 - 6 bar).
If the water pressure with the inserted water filter is too low,
this may cause the ice maker to malfunction.
The water supply to the appli-
ance must be through a cold
water pipe that can withstand
the operating pressure and com-
plies with the hygiene regula-
tions. For this, use the stainless
steel hose supplied (length 3 m).
3. Insert the bent section of the hose
through the opening at the right side
of the appliance.
4. Move the hose to the front and con-
nect with the valve connector.
Be sure the connection is tightly
arranged.
Valve connector
Installation
1. Place the appliance in front of the installation recess.
2. Apply cover strips above, bet-
ween and below the securing
plates on the side walls of the
appliance.
Cut the cover strips to the right
length for this purpose.
Fit the adhesive cover strips
leaving a gap of 6,5 mm to each
securing plate. This ensures
problem-free fitting of the cov-
ers.
2.