Filter
Top Products
22
BFI/BF1051 / BGEN/es 2956
A delight in freshness
Figure 21: Secure the refrigerator in place so it
does not tip forward when the fully stocked door
is opened.
2. Measure the distance from the floor to the
upper edge of the unit.
3. Locate and mark two wall studs (1) against the
wall where the refrigerator will be located. The
space between the unit top and the bottom
of the brackets must not be more than
1/4" (0.635 cm).
4. Make sure the screws (2) extend a minimum of
1" (2.54 cm) into each of the wall studs.
5. Make sure the anti-tip brackets (3) extend at
least 3" (7.62 cm) over the unit and are
securely in place.
BLOCKING
FOR SAFETY
IMPORTANT
The anti-tip brackets can be installed in either
direction or closer together. Always position
the anti-tip brackets as wide apart as
possible, but make sure they are anchored to
two studs.
6. Using the adjustable roller base, raise the unit
until it makes contact with the brackets. Make
sure the front levelers are firmly on the floor to
prevent appliance from tipping forward.
IMPORTANT
If your unit is positioned in between the wall
studs, a board can be secured to the wall.
Make sure the board is secured to the studs
with screws that will penetrate into the studs a
minimum of 1" (2.54 cm). The board should
be a minimum of 1" x 6" (2.54 cm x 15.24 cm)
and long enough to secure both ends to the
wall studs.
Figure 21
min 3"
1
2
3
BGEN_7082248_0929_Install_3Lang.qxd 10/21/2004 7:56 AM Page 22