Liebherr BGEN/es 2956 Refrigerator User Manual


 
BF/BFI 1051
15
DEFROSTING/CLEANING
Defrosting - Figure 12
The BioFresh compartment
defrosts automatically. The water
that forms on the rear wall drains
into a reservoir at the back of
the appliance and evaporates
automatically through the
compressor heat.
Ensure the defrost water can flow freely through
the drain hole in the rear wall (Figure 12).
Cleaning - Figure 12-13
!
WARNING
To prevent possible injury due
to an electrical shock, be sure to
disconnect the power cord or turn
OFF the circuit breaker before
replacing the interior light bulb(s) or
cleaning the appliance.
To avoid injury or damage, DO NOT
use steam cleaning equipment to
clean the appliance.
Clean the appliance by hand with lukewarm water
and a little detergent. DO NOT place components
in a dishwasher to clean.
DO NOT use abrasive or scouring sponges. DO
NOT use concentrated cleaning agents. NEVER
use abrasive or acid cleaners or chemical solvents.
Keep your stainless steel looking new by cleaning
with a good quality stainless steel cleaner or polish
monthly. High quality stainless steel cleaners and
conditioners are commercially available.
DO NOT CLEAN WITH STEEL WOOL PADS or
ABRASIVE PADS. DO NOT use cleaners that
are not for use on stainless steel, such as
glass, tile or counter cleaners. These types of
cleaners can damage the surface permanently.
Stainless steel that is exposed to chlorine gas
and moisture may have some discoloration. This
discoloration is normal. If your unit is used in this
environment, clean and polish your stainless steel
more often.
If the surface discolors or rusting appears, clean
it quickly with a non-abrasive cloth and protect it.
Always clean and polish in the direction of the grain
and finish.
To clean the storage shelves:
Figure 13. Lift the shelves, slide forward and
remove.
Always insert shelves with the guard bar at the
back pointing upwards, otherwise food may freeze
onto the rear wall.
The glass shelves are designed to prevent the
shelves from being pulled out accidentally.
To clean the BioFresh drawers:
Figure 13. Pull the drawers out and grip at the
back, and lift out.
To reinstall:
place the drawers on the extended rails, the rails
must align with the front of the drawer and slide
in.
pull the drawer cover out towards you. When
reinstalling, make sure the bearing pins snap
into place in the grooves.
The drawer and the cover must be flush with one
another vertically.
Clean the drain hole (Fig. 13) in the rear wall
frequently. If necessary, clean with a thin object, like
a cotton swab or something similar.
Ensure no cleaning water penetrates into the
electrical components or ventilation grille.
Dry all parts well with a cloth.
Figure 12
Figure 13