Liebherr WFI1051 Refrigerator User Manual


 
6
WF1051 / WFI 1051
A delight in freshness
OPERATION AND CONTROL ELEMENTS
Temperature display
In normal operation, the following settings will be displayed:
- the average wine cooler temperature in display
7 and
- the warmest frozen food temperature in display
1.
The display will ash:
- if you change the temperature,
- if the wine cooler temperature is too low or
- if the temperature rises by several degrees, indicating cold
loss, e.g. if you place fresh, "warm" food in the freezer or if
you remove or re-pack frozen food the temperature may rise
for a short time due to warm air fl owing into the freez er. Once
you have fi nished loading or re-pack ing, the electronics will
automatically re-set the temperature to the most recent set-
ting. Short-term rises in temperature will not affect the frozen
food.
W If "
F 0" to "F 5" appears in the display, the appliance has a
fault. Consult the customer serv ice department indicating the
fault number displayed as this will tell the technician what
kind of irregularity has occurred.
Power failure/FrostControl display
If appears in the display, this means that the freezer temper-
ature has risen too high during the last few hours or days due to
a power failure.
W If you press the alarm on/off button
5 whilst the display is
reading
, the highest temperature registered during the
power failure will be displayed.
Check the quality of the food and its suitability for consump-
tion in case it has become too warm or even defrosted.
- The highest temperature will appear for approx. 1 minute.
After that, the actual temperature in the freezer will re-ap-
pear. The "highest temperature" display can be switched off
by pressing the alarm on/off button.
Once the power is re-instated, the appliance will continue to
operate at the most recent temperature setting.
Audible alarm signal
The audible alarm signal helps to protect the stored wine and
frozen food from excessive temperatures and to save energy.
W The audible alarm signal is switched off by pressing the
alarm on/off button
5.
- It switches off automatically as soon as the temperature is
low enough or
- the door is closed.
Audible door alarm
- This sounds when the door has been left open for longer
than about 60 seconds.
The sound switch-off function is active as long as the door is
left open. The alarm automatically switches back to standby
when the door is shut.
Audible/visual temperature alarm
It always sounds if
- the wine storage temperature is too high or too low or
- the freezer temperature is not low enough (dependent on the
temperature setting).
The temperature display fl ashes at the same time.
This can be caused by:
- warm, fresh food being placed in the freezer;
- too much warm air from the outside entering when re-arrang-
ing or removing frozen food.
The temperature display will continue to fl ash until the cause of
the alarm has been rectifi ed. It will then stop fl ashing and light
up continually. The audible warning signal is now automatically
reset.
LightOn/Off
On/Off SuperFrost Alarm
Zone Up
Up
Down
Down
1
8
9
10
13
12
2 3 4 5
-
°F
41
64
0
-
67
Switching the appliance on and off
W To switch on: Press the on/off buttons (bn on left for wine
cooler zone and
3 on right for freezer compartment) so that
the temperature displays light up or fl ash.
- Freezer compartment: When the appliance is switched on for
the fi rst time and while it is still warm, the freezer display will
contain dashes until the temperature falls below 32°F (0°C).
W To switch off: Press the on/off buttons (
bn on left for wine
cooler zone and
3 on right for freezer compartment) for ap-
prox. one second so that the temperature displays go out.
- The freezer compartment can be operated without the wine
cooler zone. However, if the freezer compartment is
switched off, the entire appliance will be switched off.
Setting the temperature
The appliance is pre-set for normal operation. We recommend
temperatures of 46°F (8°C) to 54°F (12°C) in the wine cooler
zone and 0°F (-18°C) in the freezer.
W The wine cooler zone is divided into two compartments
whose temperatures can be adjusted independently of one
another, according to your needs. To select a temperature
zone, press button
9. The corresponding compartment will
be shown in the display.
W To reduce the temperature: Press the Down button;
8 on
left for wine cooler zone and
2 on right for freezer.
W To increase the temperature: Press the Up button.
- While you are entering the temperature, the set
temperature will fl ash on the display.
- When you press the temperature setting buttons for
the fi rst time, the most recent setting (known as the
"reference setting") is displayed.
- You can change the settings in increments of 1°F (1°C) by
briefl y pressing the buttons again. If the buttons are held
down the temperature setting will change faster.
- Approximately 5 seconds after the button has been released,
the display will automatically show the actual freezing or
cooling temperature (known as the "actual setting").
- The altered temperature adjusts slowly to the new value.
You can change the temperatures
W in the wine cooler zone:
between 64°F (18°C) and 41°F (5°C) and
W in the freezer:
between 7°F (-14°C) and -15°F (-26°C).
Whether you can obtain the lowest temperature depends on
where the appliance is positioned (if it is located in an area
with a high ambient temperature it will not reach the lowest
temperature).
-
°F
-
41
64
0