Filter
Top Products
Ice Machine Operation Section 3
3-16
Part Number 000002688
Bin Door Removal
QF0400
Door removal allows easier access for cleaning and
sanitizing.
1. Disconnect the electrical power to the ice machine
and remove ice from bin.
2. Grasp the rear of the bin door and pull bin door
forward approximately 5”.
3. Slide bin door to the rear while applying upward
pressure (the rear door pins will ride up into the track
slot).
4. Slide the rear door pins off the end and then below
the door track. Slide bin door forward allowing the
back of the door to lower into the bin. Continue
forward with the bin door until the front pins bottom
out in the track.
5. Lift the right side of the bin door until the front pin
clears the track.
6. Remove door from bin.
Cabinet Removal
QF0400
1. Remove all ice from bin and disconnect power.
2. Remove thumbscrews and evaporator panel.
3. Remove three screws from the bottom of the left and
right side of cabinet.
4. Remove nine screws from back panel.
5. Disconnect drain line clamp.
6. Slide cabinet forward and remove from base.
Track Slot
Slide Door Forward
SV2068
Press Down to
Release Door
Remove 3 Screws
From Each Side
SV2044
Remove Back
Panel screws
SV2069