Unit care
• Avoid leaning on the cabinet and freezer doors.
You may bend the door hinge or tip the unit.
• Exercise caution when sweeping, vacuuming, or
mopping near the front of the unit. Damage to the
grille and/or light switch can occur.
• For cleaning of the appliance, mix a solution con-
sisting of 2 tablespoons of baking soda with 1 quart
of warm water or use a mild soap. Do not use
strong cleaners or scouring powder or pads.
• Periodically empty ice bucket to replenish with
fresh ice.
Things to Remember
• Allow 24 hours for your refrigerator and freezer to
reach a new temperature setting.
• The unit will start and stop often. This is normal
operation of the unit.
• Keep your appliance level for proper icemaker
operation.
• Unplug the appliance before beginning any work to
the unit.
• The refrigeration section can be colder or warmer
using the adjusting slide located at the inside, left
rear section of the unit.
Interior Light
Your appliance also features an interior light. It uses a
15-watt appliance light bulb. To replace the light bulb:
1.Unplug the power cord from the wall receptacle.
Unless the unit is unplugged, the appliance light
system remains energized even with the control
knob in the "OFF" position.
2.Open the cabinet door.
3.Remove the 3 screws on the front face of the light
lens and remove the lens.
4.Unscrew the light bulb from the socket and replace
with an equivalent 15-watt, threaded intermediate
base appliance bulb.
5.Reassemble in the reverse order.
Electrical Fire Hazard
Under no circumstances replace with a bulb higher than
15 watts.
To clean the lens, disconnect the power cord and wipe
the lens with mildly damp cloth. Dry the lens and light
assembly completely before reconnecting the power cord.
3
Important: When operation of the appliance is
to be discontinued for any length of time, the ice
cube cavity in the icemaker should be emptied and
dried. The water supply and power supply should
be shut off and the ice bucket should be emptied
and cleaned.
Important: When operation of the appliance is
to be discontinued for any length of time, the ice
cube cavity in the icemaker should be emptied and
dried. The water supply and power supply should
be shut off and the ice bucket should be emptied
and cleaned.
Caution: Never pour liquids directly onto the
light assembly.
Caution: Never pour liquids directly onto the
light assembly.