Filter
Top Products
2-21
SECTION 2
INSTALLATION
5. For a TANDEM, DOUBLE TANDEM, or TRI TANDEM
oven installation, skip ahead to the next section. For a
QUAD TANDEM oven installation, continue on to Step 6.
Figure 2-29
Transition
Assembly
6. Slide the top transition panel
into place. Then, slide the
two transition side panels into
place. See Figure 2-29.
7. If the four latches are not
already attached to the side
and top transition panels,
attach them in place as shown
in Figure 2-29.
Fasten the latches on the side
and top panels to hold the
panels in place.
Latches
Latches
8. LOOSELY attach the
conveyor drive motor to the
end wall of the oven, as
shown in Figure 2-30.
9. Assemble the conveyor drive
chain in place on the motor
and conveyor drive
sprockets.
10. Position the motor to adjust
the tension of the drive chain.
The deflection of the chain
should not exceed 1/4
(6mm). Then, tighten the
motor in place.
Figure 2-30
Conveyor Motor and Drive Chain Assembly
11. Assemble the end plugs and motor housing onto the oven.
TANDEM AND DOUBLE TANDEM OVENS ONLY:
Assemble the conveyor crumb trays and conveyor
extension covers onto the oven.