Filter
Top Products
Building in and securing the
appliance
^ Depending on the thickness of the
appliance housing unit walls, push
the appliance into the niche until
– the spacer piece touches the
housing unit wall a (16 mm thick
walls), – or the front edges of the
hinges are flush with the side walls of
the housing unit b (19 mm thick
walls).
^
Press the appliance against the wall
on the hinge side.
^
Align the appliance height on both
sides by altering the adjustable feet
using the spanner supplied f.
^
Then align the appliance front to the
front edges of the side walls of the
housing unit.
^
Secure plastic bracket c to the side
opposite the hinges using the M5 x
22 screws d.
^
Push the appliance in until the plastic
bracket is flush with the front edge of
the housing unit floor e.
^
To fix the appliance to the housing
unit at the top and bottom
–
screw the long 4 x 19 mm chip board
screws a into the hinges at the top
and bottom,
–
open the plastic bracket, and screw a
long chipboard screw b (4x19mm)
through the middle of the long hole in
the plastic bracket.
^
Close the plastic bracket.
^
Close the appliance door.
Building in the appliance
40