Filter
Top Products
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If the Adjust Sensor wash function has
been activated, the amount of rinse aid
dispensed in the Sensor wash
programme can be higher than that set.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^
Switch the dishwasher off using the
On/Off button K.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
until the Start/Stop indicator light
comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Delay start button three
times.
The "Delay start" indicator will flash
briefly three times at intervals.
p3will flash in the display.
This means that the rinse aid dosage
has been set to 3 ml at the factory.
The dosage set will show in the display
after the p.
^ Use the Start/Stop button to select
the rinse aid dosage you want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Before using for the first time
23