Filter
Top Products
Water inlet/drain fault
Problem Possible cause Remedy
The Inlet/Drain
check indicator
flashes.
The stopcock is
closed.
Open the stopcock fully.
The dishwasher
stops during a
programme.
The Inlet/Drain
check indicator
flashes.
Fault code FXX
shows in the
display.
Before rectifying the problem:
–
Switch the dishwasher off
using the On/Off button K.
Fault F12/F13:
Water intake is
restricted.
–
Open the stopcock fully.
–
Clean the water inlet filter (see
"Maintenance").
–
The water pressure at the
intake is lower than 30 kPa
(0.3 bar).
Seek professional advice.
Fault F11:
Water outlet is
restricted, water
remains in the wash
cabinet at the end of a
programme.
– Clean the filter combination.
See "Cleaning and care".
– Clean the drain pump. See
"Maintenance".
– Clean the non-return valve.
See "Maintenance".
–
Remove any kink in the drain
hose.
Problem solving guide
53