Filter
Top Products
Activating Con@ctivity 2.0
41
Installation of the Con@ctivity
2.0 stick
In order for you to be able to use the
Con@ctivity 2.0 function, the cookt
op
must be equipped with a Con@ctivity
2.0 stick.
See the r
elevant installation
instructions of the Con@ctivity 2.0
stick.
Activating Con@ctivity 2.0
To use the Con@ctivity 2.0 function, the
radio link between the cooktop and the
hood must be activated.
Both appliances must be installed and
oper
ational.
You only need to carry out the
activati
on procedure once. If the
appliances are disconnected from the
electricity supply, for example during a
loss of power, they will still remain
activated.
To establish radio connection, the
ventilation hood and cooktop must be
activated at the same time.
Start activation on the ventilation hood
first, and then begin activation on the
cooktop.
Activating the ventilation hood
T
urn off the fan, cooktop lighting and
cooktop.
P
ress the Delayed shut down button
515 for approx. 10 seconds until
the 1 indicator appears in the fan
level display.
The
n, press the following buttons in
order:
– The "" butt
on
– Followed by the "" button
– And then the lighting button .
If Con@ctivity 2.0 has not been
activat
ed, the indicators for levels 2 and
3 will flash at the same time.
To activate Con@ctivity 2.0, press the
"" button.
The hood begins searching for a radio
conn
ection. Indicator 2 is continuously
lit, and the indicator 3 flashes.
As this is happening, begin activation
on the
cooktop.
Activating the cooktop
While the ventilation hood is
sear
ching for a signal, start activation
on the cooktop.
More information can be found in the
operating instructions for the
cooktop.
Once the radio connection has been
established, the indicators 2 and 3 on
the hood are continuously lit.
Confirm activation of the ventilation
Co
nfirm activation on the cooktop.