Filter
Top Products
To run the descaling programme
^
If you want to descale the machine before it has heated
up touch the sensor beside "Descale" in the initial menu to
begin the descaling programme.
^
If you want to descale the machine without being
prompted to do so by the reminder (because your water
is very hard, for example), select the "Maintenance" option,
^
Touch the sensor beside "Descale" and then the sensor
beside "ok".
The display will guide you through the whole procedure.
Please follow the instructions to, for example, empty the drip
tray, fill the water container etc.
If the machine has already heated up, it will cool down
for approx. 10 minutes before starting to run the
descaling programme.
The descaling programme cannot be cancelled once the
"OK" Sensor has been touched. The programme has to be
completed through to the end. This is a safety measure to
ensure that the machine is fully descaled, and is important
to protect the machine and ensure it functions correctly.
^
When the message appears in the display asking you
–
to add descaling agent to the water container, take the
water container out and fill it up to the k mark with
lukewarm water. (Do not use less water than this
because this would cause the descaling programme to
finish before it has been completed properly).
Add 2 descaling tablets to the water. Allow the tablets to
dissolve fully before shutting the lid and putting the water
container back in the machine.
Descaling the machine
66